Operation Manual

Advance the copying chisel, holding it at a 90˚ angle

against the workpiece.

The depth is limited with the adjustable depth stop.

Remove toolrest from toolrest holder and place the

support table into the toolrest holder. Set support table

close to the sanding disc (approx. 2 - 3 mm).

Lock the headstock spindle with the lock bar supplied

and screw the disc onto the spindle thread.

17 Disc Sanding Attachment

With the disc sanding attachment only minor sanding

jobs should be carried out, as adequate dust collecting

is not possible. Always wear a face mask when using the

disc sanding attachment.

The dust of beech and oak is carcinogenic!

It is recommended that the dust concentration in the

workshop does not exceed 2 mg/m

17.1 Sanding Discs

Remove the protective foil from the back of the self-adhesive sanding disc and stick to the disc, which has been

cleaned from all dust.

If the sanding disc needs to be replaced, simply put another sanding disc over it. This second sanding disc is then

easily removed by pulling it off when replacement is necessary.