Operation Manual

2.6
KS 304
A
Caution!
The swivelling auxiliary fence (29) must be
set to match the cutting angle of the saw: For
bevel cuts, the swivelling auxiliary fence
must be swung to the left (bevelled side fac-
ing the saw blade). Otherwise the swivelling
auxiliary fence can get caught by the saw
blade when cutting.
Workpiece clampi
The clamp of the workpiece clamp (30) can – depen-
ding on the operating conditions – can be positio-
ned to clamp from the top or the side.
A
Caution!
The workpiece clamp (31) must be posi-
tioned such that the workpiece is not under
tension (or else the workpiece can jump off
on completion of the cut or jam the saw
blade).
Table extension
The table extension (32) extents the support area
such that larger workpieces are properly supported.
Saw blade lock knob
With the lock knob (33) the saw blade is locked for
a blade change.
A
Danger!
Never press the lock knob (33) if the power
supply cable is still plugged in or the saw
blade still turning! The locking device can be
damaged when it is engaged while the saw
blade is still turning.
28
29
30
31
32
33