Operation Manual

2.8
KS 304
1. Drill four holes into the base.
2. Attach the saw with screws to the base.
Electrical connection
B
Danger! Electrical Hazard. Operate saw in
dry environment only.
Operate saw only on a power source match-
ing the following requirements (see also
"Technical specifications"):
- protected by a residual current operated
device of 30 mA capacity;
- outlets properly earthed.
Position power supply cable so it does not
interfere with the work and is not damaged.
Protect power supply cable from heat,
aggressive liquids and sharp edges.
Use only rubber-shielded cables
(H07RN-F 3 x 15 mm or similar).
Do not pull on power supply cable to unplug.
· Before starting work check to see that the fol-
lowing are in proper working order:
- saw blade;
- retractable blade guard;
- safety lock.
· Use personal protection gear:
- dust respirator;
- hearing protection;
- safety goggles.
· Assume proper operating position:
- at the front of the saw;
- in front of the saw;
- to the left of the line of cut.
· If the type of work requires, use the following:
- work support for long stock, which would oth-
erwise fall off the table on completion of the
cut;
- Dust collection bag or dust collector;
c
Danger! Entanglement hazard!
Do not wear loose clothing, jewellery, or
gloves, which may get caught and wound up
by the revolving saw blade.
Contain long hair with a hair net.
Never cut stock with the following attached:
- ropes,
- strings,
- webbings,
- cables or
- wires
or containing such materials.
A
Caution!
Cut only stock of dimensions that permit for
safe holding during the cutting operation.
Always hold the workpiece against the fence
and down on the table.
Do not jam workpiece.
Never cut several workpieces at the same
time – and also no bundles containing sev-
eral individual pieces. Risk of personal injury
if individual pieces are caught by the saw
blade uncontrolled.
Use appropriate jig when cutting round stock
to keep it from turning.
Do not attempt to stop the saw blade by
pushing the workpiece against its side.
Replace a dull blade at once.
Standard cross cuts
Starting position:
- Sawhead fully lifted
(if necessary, pull out locking pin);
- Turntable locked in 0° -position;
- Saw blade is in vertical position to the saw
table.
1. Hold workpiece against the fence.
2. Press and hold (40) ON/OFF switch.
3. Push sawhead release button and lower saw-
head, holding it at the saw handle.(39)
Operation
510 mm
340 mm
39
40