Operation Manual

ENGLISH
25
– Saw blades (please see 'Availab-
le accessories' for order num-
bers);
– safety devices (see 'Spare parts
list' for stock numbers).
x Do not change any parts.
AHazard generated by machine
defects!
x Keep the machine and accessories
in good repair. Follow the mainte-
nance instructions.
x Before any use check machine for
possible damage: before operating
the machine all safety devices, pro-
tective guards or slightly damaged
parts need to be checked for proper
function as specified. Check to see
that all moving parts work properly
and do not jam. All parts must be
correctly installed and meet all re-
quirements for proper operation of
the device.
x Any damaged parts or protection
devices must be repaired or re-
placed by a qualified specialist.
Have damaged switches replaced
by a service centre. Do not operate
device if the switch cannot be tur-
ned ON or OFF.
x Keep handles free of oil and grease.
ARisk of injury by noise!
x Wear ear protection.
x Make sure the riving knife is not
bent. A bent riving knife will push
the workpiece against the side of
the saw blade, causing noise.
4.3 Symbols on the machine
Data on the nameplate
Symbols on the machine
4.4 Safety devices
Riving knife
The riving knife (52) prevents the work-
piece from being caught by the rising
teeth of the saw blade and being
thrown back against the operator.
Always have riving knife installed du-
ring operation.
Blade guard
The blade guard (53) protects against
unintentional contact with the saw bla-
de and from chips flying about.
Always have the blade guard installed
during operation.
Push stick
The push stick (54) serves as an exten-
sion of the hand and protects against
accidental contact with the saw blade.
Always use the push stick if the di-
stance between saw blade and rip
fence is less than 120 mm.
Guide the push stick at an angle of 20q
… 30q against the saw table's surface.
When the push stick is not used, it can
be hung to the holder (55) provided.
Replace the push stick if it is damaged.
Handle for push block
The handle for the push block (57) is
screwed to a matching board (56). It is
used for safe guidance of relatively
small workpieces.
The board should be 300 to 400 mm
long, 80 to 100 mm wide and 15 to
20 mm thick.
The push block handle must be re-
placed if damaged.
37 Manufacturer
38 Serial number
39 Machine designation
38
39
40
41 42
44
37
43
40 Motor data (see also 'Technical
Data')
41 Date of manufacture
42 CE mark – This machine meets
the EC directives as per declara-
tion of conformity
43 Waste disposal symbol – Device
can be disposed of by returning it
to the manufacturer
44 Dimensions of permissible saw
blades
45 Wear ear protection
46 Wear eye protection
47 Do not operate tool in moist or
wet environment.
48 Read operating instructions
49 Do not reach into saw blade area
50 Hazardous area warning
51 TÜV-tested safety
45 46
48 49 50
51
47
52 53
54
55