Operation Manual

ENGLISH
29
– from the inside screw on flange
nuts (92) – do not yet tighten ful-
ly.
2. Mounting the guide bar (90): Insert
the guide bar into the mounting
bracket (94) so that the nose fits
into the slot in the guide bar. A
slight turn of the guide bar keeps it
from sliding off.
3. Slide the lower fence carrier (91)
with the angle facing the front of the
saw on the guide bar and swing it
down.
4. Put the rear mounting bracket (95)
on the guide bar and secure by tur-
ning it slightly.
5. Attach the rear mounting bracket
with the bracket (97) for table exten-
sion installation to the saw.
3 Note:
The second bracket (97) for installation
of the table rear extension is installed to
the right rear edge of the table top (not
illustrated).
6. Align guide bar so that it is exactly
parallel with the saw blade.
7. Tighten all screws holding the
mounting brackets.
8. Fit plugs (96) to both ends of the
guide bar.
9. Swing the lower fence carrier up.
10. Install the upper fence carrier (101)
with washer (100) and star-knob
screw (99).
11. Put the short fence extrusion (102)
on and secure with knurled nuts
(103):
– the plastic nose of the fence ex-
trusion must point towards the
saw blade;
– the washers (104) must be fitted
between upper fence carrier and
knurled nuts.
12. By means of the set screw (98) the
fence extrusion can be set exactly
square to the saw blade. The set
screw (98) is accessible when the
mitre fence is swung down.
3 Note:
When the mitre fence is not required,
swing it down, out of the way.
Adjusting the rip fence
1. Slide rip fence (108) on the guide
rail and lock with the lock lever
(107).
2. Install the fence extrusion (105) as
illustrated below and secure it with
the two knurled thumb screws.
3. Slightly loosen both set screws
(106) of the rip fence and align the
fence extrusion parallel with the saw
blade. Retighten both set screws af-
terwards.
4. Set rip fence against the right-hand
side of the saw blade, across its
entire diameter. Raise the saw bla-
de by means of the crank handle if
necessary.
5. Adjust scale so that its zero position
coincides exactly with the scale rea-
ding edge (109) of the rip fence.
6. Tighten the scale fastening screw
and verify the setting by making a
trial cut.
Wheel set installation
The wheel set attaches to the rear legs
of the saw.
1. Each of the wheel set brackets
(110) must have two hexagon head
screws (111), with washers fitted
(112) put through it from the rear.
2. Screw on the flange nuts (113) from
inside the leg.
3. Adjust position of brackets so that
the wheels are approx. 1 mm above
the floor when the saw is standing
on all four legs.
90 91 92
93
94
95
96
97
99
100
101
98
102
104 103
Item Description Qty.
110 Wheel set 1
111 Hexagon head screw
M6 x 16
4
112 Washer 6.4 4
113 Flange nut M6 4
105
106
107
108
109