Operation Manual

ENGLISH
30
4. Tighten flange nuts.
Installing the table extension
A Caution!
When installing the rear table exten-
sion, both panel and support struts
need to be held as long as they are
only bolted to one end.
1. Fasten extension panel (114) with
two bearing bolts (117), two was-
hers (115) and two flange nuts
(116) to the two brackets as illustra-
ted.
If necessary, adjust the position of
the brackets to match the width of
the table extension – retighten the
bolted connection.
2. Attach each of the supports (120)
with one bearing bolt (121), one
washer (118) and one flange nut
(119) to the table extension (see il-
lustration).
3. Tighten all bolted connections of the
table extension hand-tight using a
suitable tool.
3 Note:
The supports of the table extensions
can be fixed securely in place. Alterna-
tively, they can be installed in such way
that the table extension can swing
down.
Stationary support installation
1. Insert the offset ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside.
2. Fasten each of the supports with
one countersunk screw (123) and
one prevailing torque-type hexagon
nut (122) to the strut as illustrated.
Support installation for folding down
of table extension
1. Attach one countersunk screw (125)
and one prevailing torque-type he-
xagon nut (124) to the lower end of
each of the struts.
2. Insert the lower ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside (see illu-
stration).
Tightening the screwed connections
x Check all screwed connections of
the saw. Tighten all screwed con-
nections hand-tight with a suitable
tool.
Observe the following when tighte-
ning the screws:
– The machine must stand firmly
and levelly after the screws have
been tightened.
– Adjusting the table extension: the
table extension's surface must be
parallel with and in the same pla-
ne as the top of the saw table.
Swinging the table extension down
1. Slide the lower ends of the supports
towards each other.
2. Lift supports out of the strut and
swing table extension down as illu-
strated.
Transport handle installation
Item Description Qty.
114 Plate, table rear
extension
1
115
118
Washer 8.4 4
116
119
Flange nut M8 4
117
121
Bearing bolt
M8 x 10
4
120 Support 2
122
124
Hexagon nut, prevai-
ling torque-type M6
2
123
125
Countersunk screw 
M6 x 10
2
110
111
112
113
114
116
117
115
121
119
120
118
122
123
Item Description Qty.
126 Transport handle 2
127 Hexagon head screw
M6 x 16
4
125
124