Operation Manual

ENGLISH en
19
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
Ø =max. diameter of the accessory
t
max,1
=max. permitted thickness of clamping
shank on accessory when using clamping
nut (13)
t
max,2
=max. permitted thickness of clamping
shank on accessory when using "Quick"
clamping nut (1)
t
max,3
=roughing disc/cutting disc:
max. permitted thickness of accessory
M=spindle thread
l =length of the grinding spindle
n =no-load speed (maximum speed)
P
1
=rated input power
P
2
=power output
m =weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~ AC Power
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value
(vector sum of three directions)
determined in accordance with EN 60745:
a
h, SG
=Vibration emission value (surface
grinding)
a
h, DS
=Vibration emission value (disc sanding)
K
h,SG/DS
= Uncertainty (vibration)
Typical A-effective perceived sound levels
:
L
pA
= Sound-pressure level
L
WA
=Acoustic power level
K
pA
, K
WA
= Uncertainty
Wear ear protectors!
14. Technical Specifications