Installation Guide

1.25" Corrugated

2.5" Corrugated

CORRUGATED PANEL INSTALLATION

INSTALLING FIRST PANEL

INSTALLING CLOSURES

INSTALLING

PANEL CLIP

STEP

CLOSURE

WITH TAPE SEALANT

TAPE SEALANT

(on top of closure not shown)

CLOSURE

WITH TAPE SEALANT

ROOF PANEL

1. Apply a row of Tape Sealant across the top leg of the Eave Flashing along the width of

the building.

2. Align and place Closures over the Tape Sealant. It is critical that Closures are square to build-

ing as this will control the alignment of the panels.

(see page 16 to check building square).

3. Apply a row of Tape Sealant across the top of the Closure (Not shown for clarity).

1. Install the rst panel over the Closure to allow for desired overhang. Make sure the panel is

square to the eave and rake.

2. Fasten through panel, Closure and Tape Sealant into decking with appropriate amount of fas-

teners to meet local building code. (see fastening patterns on page 7 and 9). Fasteners must

penetrate Closures and Tape Sealant.

3. After securing panel at eave, repeat the fastening pattern at the appropriate spacing to meet

local building codes.

NOTE: -Eave, Gutter and Valley Flashings must rst be installed before panel installation can begin.

-Panels can be installed going from either left to right or right to left, looking from eave to peak.