Installation Manual

STILE

1. Install the Rake Starter along the edge of the roof beginning at the eave and stopping at the

ridge. Align the vertical leg of the Rake Starter flush with the edge of the rake. Attach with a

Woodscrew XL fastener in the extended leg of the trim 3" up from the eave. Place fasteners

along the Rake Starter 1'-0" o.c.

2. If two or more Rake Starters are required, lap the flashing over the previously installed flashing

by a minimum of 3" placing a bead of Tube Sealant between the flashings along the edge where

they lap. The last Rake Starter should be field cut

/2" from the ridge. The final fastener on this

run should be located 3" down from the ridge.

INSTALLATION OF RAKE STARTER

RAKE STARTER

WOODSCREW XL