Installation Manual

STILE

INSTALLATION OF PANEL (CONT)

1. Stile panels are available in lengths from 3'-0" to 20'-0" in one foot increments. For runs longer

than 20'-0", panels are designed to endlap.

2. Endlaps can be placed staggered or in-line with the previous panel endlap. Either method of

installation is suitable, but in-line endlapping tends to be easier to order and install.

3. Follow the panel installation sequence as shown below. Regardless of which method you use,

install panels from right to left, lapping the ridge panel over the eave panel.

4. Fasten panels with a Woodscrew XL fastener at every other valley and every third step of the

panel (see page 25). Fasten at the endlap in every valley just below the step in the panel.

ENDLAPPING OF PANEL

IN-LINE ENDLAPPING

6421

8753

PANEL INSTALLATION DIRECTIONPANEL INSTALLATION DIRECTION

EAVE

RIDGE

In a staggered endlap example a 28'-0" run

would be covered with panel lengths of 15'-0"

and 13'-0" alternating right to left.

In an in-line endlap example a 28'-0" run

would be covered with 14'-0" panels at both

the top and the bottom of the run.

STAGGERED ENDLAPPING

WOODSCREW XL

SEALANT

ENDLAP

FASTENING PATTERN AT ENDLAP

WOODSCREW XL

STILE PANEL