Installation Manual

STILE

INSTALLATION OF PANEL (CONT)

1. All Stile panels meeting the valley must be field cut at an angle so that the panels stop 3" from

the center of the valley.

2. When starting Stile panel near a valley, tilt the right side of the panel

/16" lower than the left

side. This is required to keep the panel thickness from accumulating at the eave (see page 24).

3. A foam Universal Closure or Stile Closure is placed between the previously installed Valley

flashing and Stile panel. Tube Sealant is used with the closure to prevent moisture and

debris from getting under the panels.

4. Woodscrew XL fasteners are required along the edge of the cut panel just below each step.

5. Place a fastener at every other valley and every third step throughout the panel.

6. Optional Valley Cover is installed over the Stile panel at the valley. Fasten the Valley Cover to the

rib of the Stile panel with a

/8" Pop Rivet on both sides of the Valley Cover at 1'-0" o.c.

1. All panels meeting the hip must be field cut at an angle so that the Stile panel fits into the

previously installed Stile C-Closure (see page 22). When Formed Ridge flashing is used, Stile

C-Closure is not required.

2. When starting Stile panel near a hip, tilt the right side of the panel

/16" lower than the left

side. This is required to keep the panel thickness from accumulating at the eave (see page 24).

3. Woodscrew XL fasteners are required along the edge of the cut panel just below each step.

4. Place a fastener at every other valley and every third step throughout the panel.

PANEL AT VALLEY CONDITION

ICE AND WATER SHIELD

WOODSCREW XL

UNIVERSAL CLOSURE

VALLEY FLASHING

WOODSCREW XL

STILE PANEL BEVEL CUT IN FIELD

PANEL AT HIP CONDITION