Installation Manual

STILE

INSTALLATION OF FORMED RIDGE

FORMED RIDGE

STILE CLOSURE OR UNIVERSAL CLOSURE

(UNIVERSAL USED ON HIP ONLY)

TUBE SEALANT

POP RIVET

STILE PANEL

FORMED RIDGE

1. Position the Formed Ridge at the peak of the roof and square with the front edge of the Formed

Rake.

2. Align the Formed Ridge so that the flanges extend down on each side of the roof equal distance.

3. Place Stile Closure under the flange on each side of the Formed Ridge.

4. Place

/8" Pop Rivet in the flange of the Formed Ridge so that the Formed Ridge is fastened to the Stile

panel at the top of every other rib of the panel. Do not install the last fastener until the next piece of

Formed Ridge has been overlapped with the installed Formed Ridge.

5. After all the Formed Ridge has been installed, close off the ridge at each end of the roof by placing a

Ridge Closure End Plug in the open area.

WOODSCREW XL

MOISTURE BARRIER

STILE CLOSURE

FORMED RIDGE

STILE PANEL

SIMPLE RIDGE CONDITION

STILE FORMED RIDGE CLOSURE

FORMED RAKE

POP RIVET