User's Manual

Appendix 2 – Network Installation

There are several possible ways to set up Ojo as part of your home

network. Several typical home network configurations that include Ojo are

described below.

You can set up Ojo anywhere in your house (it doesn't have to be

right next to the modem) using Homeplug™ technology.

Homeplug is a new technology that allows you to use household

power outlets to replace any Ethernet connection. For more

information about using Homeplug in your home network, visit

www.homeplug.com

If your cable modem is connected to a single computer (or other

device), Ojo can be connected to the modem and computer as shown

below:

To connect Ojo in this manner, turn off the modem power switch,

then plug one end of the provided Ethernet cable into the “TO

MODEM” port on the back of Ojo, and the other end into the cable

modem. Connect the Ethernet cable from the PC to the “TO

COMPUTER” port on the back of Ojo. Then connect the telephone line,

turn on the modem power switch, and power up Ojo (see page 14 for

details).

Note: This manner of connecting Ojo is not recommended and will

not work if you are using a USB port on your computer or if you have

a DSL modem that requires PPPoE support.