Instructions / Assembly

Lightly tighten the upper clamps above the sixth rung on each corner post. Position the lower clamp

above the bottom rung. Ensure the lower arm is as horizontal as possible. Position the stabilisers

so that the footpads are approximately equidistant from each other, as shown in Fig.2. Adjust the

outrigger and reposition the clamps as required to make contact with the ground. Ensure the

clips with locking pin are in place. When in the correct position, tighten the clamps

To position the tower against a wall, do not remove the stabiliser; move parallel with the wall. (Fig.3)

To position the tower in a corner, remove the inside stabiliser and place the outside two parallel with

the wall. (Fig.4)

STABILISERS

are to be used, when specified, to guarantee the structural stability of the tower.

Fig.2 Fig.3 Fig.4