Product Manual

ASSEMBLY INSTRUCTIONS

Engage the first handle bar (“C” shape) on the cart platform. With a rubber mallet, firmly hit each upper ends of

the handle, as shown in the figure below (1), make sure that the handle is fully inserted by verifying that holes of

the handle bar are aligned with those on the cart platform. Do not screw anything at this stage.

Join the top of the second handle bar (“H” shape) with the first handle bar installed, as shown in the diagram

below (2), do not screw anything at this stage. Engage the “H” handle bar on the cart platform. With a rubber

mallet, firmly hit each side of the central tube, as shown in the diagram below (2), make sure that the handle is

fully inserted by verifying that holes of the handle bar are aligned with those on the cart platform.

Put together the tops of both handle bars using two 3/4 in. barrel nut and two 1 in. carriage bolt supplied. Make

sure that everything is firmly screwed.

Fasten the assembled handle bar to the cart platform using four 2 in. hex bolts and nuts supplied. Make sure that

everything is firmly screwed.

Lay down the cart on its side to install casters. Firmly screw the casters under the cart using sixteen 3/8 x 1 in.

hex bolts and washers supplied.

BOX CONTENTS

QTY. PART CODE DESCRIPTION

2 VB-NB1_4X3_4Z 3/4 in. barrel nut

2 VB-BC1_4X1Z 1 in. carriage bolts

4 VB-B3/8X2Z 2 in. hex bolts

16 VB-B3/8X1Z 1 in. hex bolts

4 VB-N3/8Z 3/8 in. hex nuts

16 VB-WL3/8Z 3/8 in. lock washers

1 321101900 Cart platform

1 321102100 “C” handle bar

1 321104900 “H” handle bar

1 I-DCCRL Swivelling caster with lock

3 I-DCC8R Swivellings casters

THE USE OF A RUBBER MALLET IS RECOMMENDED TO

AVOID DAMAGE TO THE COMPONENTS OF THE CART.

(NOT INCLUDED)

ENGLISHENGLISH

16x