Installation Guide
Instruction Manual/Instrucciones/Directives
Questions?/¿Preguntas?/Questions ? 1-800-334-6871 ConsumerProducts@cooperlighting.com
1
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: FCC Regulations state that any unauthorized changes or
modifications to this equipment not expressly approved by the manufacturer
could void the user’s authorization to operate this equipment.
SAVE THESE INSTRUCTIONS.
INSTALLATION INSTRUCTIONS
1. Before installation, plug fixture into a 120V, 60Hz electrical outlet to check for proper
operation. Then unplug and begin the installation. DO NOT ATTEMPT TO INSTALL WHILE
PLUGGED IN.
2. Product may be suspended mounted or bracket mounted to either a stud or dry wall.
Mounting hardware should be suitable for the intended application and mounted 44” apart
for chain mount applications and 41” apart for bracket mount applications.
3. For stud chain mount applications insert (2) #8 or larger diameter open screw eye
hooks into a wood joist. Continue to step 5. (Fig.1)
4. For drywall mount applications drill hole to fit included wall anchor and screw surface
bracket to ceiling. Go to step 7.
5. Loop S-hooks to back of housing end. (Fig. 2). Go to step 6 to level fixture.
PACKAGING CONTENTS/CONTENIDO DEL PAQUETE/CONTENU DU PAQUET
ITEMS REQUIRED
(Purchase separately)
• Pliers
• Power Drill
• Ladder
• Safety Glasses and Gloves
• Screwdriver
WARNINGS AND CAUTIONS
• For suspended or bracket mount only, Do not surface mount light fixture.
• Do not install on a radiant-heating ceiling.
• Do not use in wet location.
• Only install using length of chain as provided with luminaire.
• Minimum operating room temperature of -20˚C recommended.
• This unit is intended to be installed directly below receptacle.
• Never alter length of power cord.
• Mounting hooks should engage the chain only, product is not intended to be suspended by
the electric cord set.
• Fixture should be installed by persons with experience in household wiring or by a qualified
electrician. The electrical system, and the method of electrically connecting the fixture to it,
must be in accordance with the National Electrical Code and local building codes.
This device complies with the FCC Rules and CAN ICES-005 (B) / NMB-005 (B).
Operation is subject to the following two conditions
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason able
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
There is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
ENGLISH
A. (2) Mounting chains
(2) Chaînes de montage
(2) Cadenas de instalación
D. (4) Wall anchors and screws
(4) Ailes coniques et ancrages muraux
(4) Alas cónicas y anclajes de pared
B. Switch pull string
Corde de commutateur
Cuerda interruptor
Open screw eye
Joist
1
#8 or
larger open
screw eye
C. (2) Surface Bracket
(2) Support de surface
(2) Soporte de superficie
E (4) S-hook
(4) Crochet en S
(4) Gancho en S
F. (2) Eye Screws
(2) Vis à oeillet
(2) Tornillo de ojo
4
2 3
Chain
Surface
bracket
Linkable up to
max 4 fixtures
To 120VAC
WallOutlet