Instruction manual

Loading the Media

METAPACE L-3 printers can be operated in three different modes:

Standard mode, Peel-off mode, or Cutting mode.

-- In Standard mode, each printed label remains on the backing liner.

-- In Peel-off mode, each printed label is peeled away from the backing

liner manually.

-- In Cutting mode, the printer automatically cuts the label after it is

printed.

Standard Mode

1. Lift the Positioning Arm of the Media Roll, insert the media roll

onto the media spindle to the inside edge;

2. Adjust the Positioning Arm, push it down, align it to the outside

edge of the media roll and lock it in place;

3. Turn the lever anticlockwise to release the Printhead Module;

4. Refer to Figure 5, lead the media through and under the media

guide lever, in between the media sensor;

5. Pull the media passed and under the printhead(Figure 7);

6. Move the media sensor to the appropriate position᧤Figure 8᧥:

adjust the media sensor to ensure that the Sensor Position is

aligned with the proper identifier (gap, black line, perforation,

hole, etc.)