Instruction manual

19
MAIN MENU
SUB MENU
DESCRIPTION
Common Settings
Print Method
Direct Thermal, Thermal Transfer.
Default: Thermal Transfer.
Tear Off
Options: Enable, Disable.
Default: Disable.
Cutter
Manual Peel Off
Media Sensor
Options: Reflective, Transmissive.
Default: Reflective.
Baud Rate
Options: 9600, 19200, 38400, 57600.
Default: 9600.
Darkness
When set at ‘0’, the printer will accept
the default setting or command setting,
if not, the printer will not accept the
default setting or command setting.
Speed
Return Return to main menu.
Offset settings
Tear-off Offset
The increment for the METAPACE
L-32 is 0.125mm, METAPACE L-33
0.085 mm, METAPACE L-36 is 0.0423
mm.
Positioning Offset
Cutting Offset
Peeling Offset
Return
Return to main menu.
Network
Configuration
IP Address
The range of XXX is 0-255, press
PAUSE( )to decrease, CANCEL( )
to increase, FEED( )to move to
next XXX. Upon completion, pressing
FEED( ) will proceed to the
“Save/Abort” screen.
Port
Subnet Mask
Gateway
Return
Return to main menu.
Language
Selection
Chinese
English
Return
Return to main menu.
Clear
Settings
Clears only those settings accomplished
through the front panel.
Graphics
To View, or Del All, or Del 1 by 1.
Return Return to main menu.
Stand Alone
Printing
Execute
Execute stored forms.
Delete All
Delete all stored forms.
Delete 1 by 1
Delete selected stored form.
Return
Return to main menu.
Self Test
Font list, hardware configuration and status, label parameters,
firmware version, etc. will be printed.
Reset
Reset the printer to the factory default settings.