Instruction manual

Adjusting The Pressure Of Printhead

Figure 11

As shown in Figure 11, there are two screws, #1 and #2. Unscrew #2

first᧤do not remove it᧥, then unscrew #1. Adjust the position of screw #1

towards Increase or Decrease as required. Then first fasten screw #1,

then the #2.

Windows Driver and Metapace Label Designer Software

The printer driver supports Windows Vista/2003/XP/2000/NT/ME/98/95

operating systems. Each METAPACE L-3 printer comes with powerful

bar code label design software Metapace Label Designer and operating