User manual

Update

Chapter 1

Understanding the Barcode Scanner

1.1.2.2 AUTO POWER OFF

For the scanner to save power, further to setting up “Power-Saving” mode, you may also

need to enable “Auto Power Off”, which deals with a time for the scanner to automatically

power off after power-on. Make the configuration that best suits your application while

noting the following points:

 Auto Power Off: 1~254 minutes configurable. 0= Disable.

1. By default, the scanner automatically shuts down 10 minutes after power-on.

2. If Auto Power Off isn’t desired, set the parameter to 0 to disable it.

3. When the scan mode is set to Test Mode, you need to enable “Auto Power Off

Ignoring Scan Mode” in addition to enabling “Auto Power Off”. See the following

section

1.1.2.3 Auto Power Off Ignoring Scan Mode to achieve auto power off.

Note: When the scanner is set to any scan mode other than Test Mode, you can skip

“Auto Power Off Ignoring Scan Mode”.

Auto Power

ff after

0~254 min. (*10)

1) Read the barcode above to enable the scanner to automatically turn off at a specified

time after power-on.

2) Assign the auto power off time by reading the “

Decimal Value” barcode on page 237.

For example, read “1” and “5” for the scanner to automatically turn off after idleness

of 15 minutes.

3) Read the “Validate” barcode on the same page to complete this setting.

Note: “Auto Power Off” will not take effect when the scanner is in the configuration

mode.

1.1.2.3 AUTO POWER OFF IGNORING SCAN MODE

This mode is intended only for Test Mode. To force a scanner that is set to Test Mode to

automatically power off to save power, you need to finish the following settings:

1. Enable “Auto Power Off” as detailed in the foregoing section

1.1.2.2 Auto Power

Off

. And set a time for the scanner to automatically power off after power-on.

2. Enable “Auto Power Off Ignoring Scan Mode” by reading the barcode below: