Hardware manual

138
Enter Setup
Metapace S-2 Hardware Manual
5.2 CHARACTER SUBSTITUTION
Character substitution is performed on every occurrence of the first character specified. If
only one character is specified, every occurrence of that character in the barcode will be
taken away.
 The first character will be replaced by the second character(s).
 Up to three sets of character substitution can be configured.
 If “BT HID”, “USB HID” or “Keyboard Wedge” is configured for interface, Key Type
and
Key Status will then become applicable. You may decide whether or not to apply
Key Status when “Normal Key” is selected for Key Type. Refer to Appendix II
Keyboard Wedge Table.
Key Type
Key Status
Scan Code Only 1 scan code value is allowed.
Refer to 5.2.1 Select a Set for
Character Substitution.
N/A
Normal Key Up to 3 character strings are allowed.
 Add Shift
 Add Left Ctrl
 Add Left Alt
 Add Right Ctrl
 Add Right Alt
 Add Break
For example, read labels for [A], [Add
Shift], and [B] to replace the character [A]
with [Shift+B].
Note: The character substitution is performed only on the barcode itself and before the
processing of editing formats. It is not applicable to the Prefix/Suffix Code, Code
ID, Length Code, or any Additional Field.