Hardware manual

Enter Setup

Metapace S-2 Hardware Manual

ENTER CONFIGURATION MODE

For the scanner to enter the configuration mode, you must have it read the "Enter Setup"

label, which can be located at the bottom of almost every even page of this manual.

 The scanner will respond with six beeps and its LED indicator will become flashing red

after reading the label.

For configuring scanner parameters, see “Read a Setup Label” below.

EXIT CONFIGURATION MODE

For the scanner to save settings and exit the configuration mode, you must have it read

the “Update” label, which can be located at the bottom of almost every odd page of this

manual. If you want to exit the configuration mode without saving any changes, have the

scanner read the “Abort” label instead.

 Just like reading the “Enter Setup” label, the scanner will respond with six beeps and

its LED indicator will become flashing red after reading the label. Wait for a few

seconds for the scanner to restart itself.

Update

Abort

nter Setup