Hardware manual

32
Enter Setup
Metapace S-2 Hardware
Manual
1.6.1 CONTINUOUS MODE
The scanner is always scanning.
 After a successful decoding, the removal of barcode is required. It is not allowed to
proceed to decode until the decoding delay time has passed.
 To decode the same barcode repeatedly, move away the barcode and put it back
again and again for scanning.
Note: Refer to “Delay between Re-read”.
Decoding Delay
Set the time interval between each decoding.
C
ontinuous Mode
*Disable
0.5 sec
1 sec
2 sec