Hardware manual

86
Enter Setup
Metapace S-2 Hardware Manual
3.1.2 CHANGE INTERFACE
If you want to change the interface cable of the cradle, use one of the scanners to
configure the interface-related settings and it will pass the new settings to the cradle,
which will then initialize and pass the settings to any other connected scanners.
1) Have the scanner read the “Set Connection” and “Serial Number” labels at the back of
the cradle.
2) Within two minutes, connect the interface cable, Keyboard Wedge, RS-232 or USB,
between the cradle and your computer. For USB Virtual COM, you may need to install
its driver first!
3) The scanners will connect to your computer via the cradle.
4) Have one scanner read the “Enter Setup” label to enter the configuration mode.
5) Have the scanner read the desired interface label and configure its related settings –
 “Activate Keyboard Wedge & Select Keyboard Type”
 “Activate RS-232”
 “Activate USB HID & Select Keyboard Type”
 “Activate USB Virtual COM”
6) Have the scanner read the “Update” label to exit the configuration mode.
7) After the scanner resumes connection with the cradle, it will pass the
interface-related settings to the cradle.
8) Upon receipt of the new settings, the cradle will initialize itself.
9) Updated with new settings, the cradle will pass the settings to other connected
scanners.