Specifications

3-6
3 - 6
LED Illumination - Manual Trigger
If you wish to set the illumination LED brightness, scan one of the bar codes
below. This sets the LED illumination for the scanner when the trigger is
pressed.
Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the
room, the brighter the LEDs need to be so the scanner can “see” the bar
codes.
In-Stand Sensor Mode
This feature senses when the scanner is removed from the stand and tells it to
begin manual triggering. When Sensor On is enabled, the scanner defaults to
Presentation Mode when it is in the stand, and to Manual Trigger Mode when it
is removed from the stand.
Default = Sensor On.
Off
Low
Medium
Medium High
* High
* Sensor On
Sensor Off