Specifications

3-7
3 - 7
Presentation Mode
Presentation Mode uses ambient light to detect bar codes. The LED dims until
a bar code is presented to the scanner, then the LED brightens to read the
code. If the light level in the room is not high enough, Presentation Mode may
not work properly.
LED Illumination - Presentation Mode
If you wish to set the illumination LED brightness, scan one of the bar codes
below. This sets the LED illumination for the scanner when it is in Presentation
Mode. (If the scanner is triggered manually, the LED illumination will switch to
the setting for a manual trigger. See LED Illumination - Manual Trigger on page
3-6.)
Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the
room, the brighter the LEDs need to be so the scanner can “see” the bar
codes.
Presentation Mode
Off
Low
Medium
* High