Install Manual

Disconnect spark plug wire. If replacing old

rope, measure and cut new rope to same

length as the old. Tie a knot in the end of

the rope and heat-seal end to prevent

loosening. (If only replacing new handle

on existing rope, tie a knot in current rope

near the old handle & then cut-off old

handle).

2. Push the knot down through the “+” on

the inside of the handle. Pull the rope

completely down through the slot until it is

tightly seated inside the handle. (If not

replacing rope, skip to 4).

3. Remove the recoil housing from

engine. Rewind starter spring

counterclockwise until tight. Install rope

through the eyelet, tie a knot, and pull

tight. (Consult your owner’s manual)

4. Reconnect spark plug wire.

PAGE 1
Disconnect spark plug wire. If replacing old rope, measure and cut new rope to same length as the old. Tie a knot in the end of the rope and heat-seal end to prevent loosening. (If only replacing new handle on existing rope, tie a knot in current rope near the old handle & then cut-off old handle). 2. Push the knot down through the “+” on the inside of the handle. Pull the rope completely down through the slot until it is tightly seated inside the handle. (If not replacing rope, skip to 4). 3.