Operations Manual

OPERATIONS 4-56
O&M of the MCC-545B PACKET DATA RADIO
12/2000
†$PENTM,ALERTMSG
S {,nnn...}
Define canned messages constituting an alert. Any
number may be defined (up to 10 per line). Intercepted
messages matching one of these numbers cause an alert
message to be sent to the local MNT and DTA ports.
nnn = canned
message number
1 – 120
$PENTM,command string Send command string to local Entek MDP. command string =
any valid Entek
MDP command
string
†$PENTM,action Enable/disable Entek MDP interface. When enabled,
allows communication with mobile data processor in
vehicle tracking applications and causes received status
bits from the MDP to be included with the position data
in the Remote's data reports.
action =
ON – enable
OFF – disable
†POLL{interval,offset,
duration,retry}{,ALWAYS
}
Define/display polling schedule for Base/Repeater
Station. If ALWAYS parameter specified, do not
timeout on-line units (i.e., ignore retry count in this case).
interval = polling
interval in
seconds
offset = offset
from top of
minute
duration = length
of poll
retry = retry count
for failed polls
1 – 86400
1 – 59
1 – 10
1 – 99
*POS{,interval,format,
protocol}
Display/initialize internal 545B timing for reporting GPS
position data. Specify update period in seconds, in either
binary or text format, using given protocol.
interval =
reporting interval
in seconds
format = display
format
protocol = GPS
unit protocol
0 – 65535
BINARY, TEXT
NMEA, ARNAV,
TAIP, TRANSAS