Specifications

APPENDIx A

U.S.A. DIGITAL EMISSIONS COMPLIANCE

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be required to correct the

interference at his own expense.

CANADIAN DIGITAL APPARATUS COMPLIANCE

This device complies with Industry Canada license-exempt RSS standards. Operation is

subject to the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that may

cause undesired operation.

CANADA CLASS A STATEMENT

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

RADIO PRECAUTION STATEMENT

Radio transmitters IC-5123A-MGM12P0, IC-25859-H110A00, and IC-25859-H310A00 have

been approved by Innovation, Science, and Economic Development Canada to operate with

the antenna types listed below, with the maximum permissible gain indicated. Antenna types

not included in this list that have a gain greater than the maximum gain indicated for any

type listed are strictly prohibited for use with this device.

Maximum Gain: 4.15 dBi, 50 ohm, Vertically polarized, dipole antenna.

802.11 RADIO PRECAUTION STATEMENT

CAUTION: Users are responsible for configuring the channels of operation that comply with

their country’s regulatory standards. A Wireless Network Administrator should review the

operating restrictions detailed within the Access Point installation manual.

CAUTION: See battery instructions. No user-serviceable parts. Charge only according to

instructions in Section 7.2. Use of incorrect charger may present a risk of fire or explosion.