Specifications

6
OPERATION
Table 4 H311 Sensor Station Installation (continued)
Connecting
Connect Router to Internet and Verify
The Sensor Station is shipped to the customer in SLEEP mode, indicated by a
solid red STATUS LED light.
To wake the Sensor Station up, press the button (Figure9) one, two, or three
times to trigger the green LED. The device has enetered the ON mode when the
STATUS LED shows solid green.
NOTE: The unit toggles between ON and SLEEP mode after the button is pressed three
times. It remembers when the three button presses happen, even if they are days apart. If
the button is pressed once today, once tomorrow, and once the following day, the base will
either turn ON or go into SLEEP mode, depending on what state it was in prior to the third
button press.
Follow the steps listed in Table 5 to set up the AROYA Sensor Station.
Table 5 H311 Sensor Nose Installation
Tools Needed
AROYA Sensor Nose
Preparation
Consider the Surroundings
The Sensor Nose is used with slabs or larger substrate types. The TEROS 12
needles are inserted into the slabs or larger substrate. Make sure there is
adequate table space near the slabs or larger substrate to place the Sensor
Nose on so enough light can reach the solar sensors to recharge battery..
Check Sensor Functionality
Press the function button (Figure11) until the LED flashes green.
Mounting
Insert sensor into slabs or larger substrate types.
Configuration
All system configuration work is done at METER before installation occurs at
the customer site.
Connecting
Connect Router to Internet and Verify
The Sensor Station is shipped to the customer in SLEEP mode, indicated by a
solid red status LED light on the end where the cable is connected.
To wake the Sensor Station up, press the button one, two, or three times to
trigger the green LED. Status LED showing solid green indicates the device has
entered the ON mode.
NOTE: The unit toggles between ON and SLEEP mode after the button is pressed three
times. It does not matter when the three button presses happen. For instance, if the button
is pressed once today, once tomorrow, and once the following day, the base will either turn
ON or go into SLEEP mode, depending on what state it was in prior to the third button press.