User Manual
Table Of Contents
- 0.0 version and updates
- 1.0 Overiew
- 2.0 pay attention to safety matters
- 3.0 Performance description
- 4.0 Appearance structure
- 5.0 Technical Specifications
- 6.0 Main Page
- 7.0 Expansion of recording function
- 8.0 Quick charge protocol trigger and detection menu
- 9.0 Charging tool
- 10.0 setting menu
- 10.1 Settings menu -> General
- 10.1.1 Setting menu -> General -> Display brightness
- 10.1.2 Settings menu->General->Standby brightness
- 10.1.3 Settings menu->General->Standby time
- 10.1.4 Settings menu->General->Data transmission
- 10.1.5 Setting menu->General->Temperature symbol
- 10.1.6 Settings menu -> General -> System language
- 10.1.7 Settings menu -> General -> Current change wake up
- 10.1.8 Settings menu->General->Bluetooth switch
- 10.1.9 Settings menu -> General -> Gravity direction recognition
- 10.1.10 Settings menu->General->Startup page
- 10.1.11 Settings menu->General->Restore factory settings
- 10.2 Settings menu -> record
- 10.3 Settings menu -> trigger
- 10.4 Settings menu -> system
- 10.1 Settings menu -> General
- 11.0 Upgrade firmware instructions (NOTEļ¼The previous FNB38 and FNB48 use the FNIRSI USB Meter upgrade tool.FNIRSI-C1 uses FNIRSI UsbMeter Computer Software to upgrade the firmware now.)
- 12.0 Frequently Asked Questions
(1) Long press the left button: prompt to enter the fast charge trigger module, if a
certain protocol has been triggered, it will prompt to release
(2) Click the OK button: start/stop the trigger timing.
(3) Long press the middle button: prompt to clear and trigger timing.
(4) Long press the right button: enter the charging tool menu (please see the
following instructions).
6.0.4 Curve display page
Description
Mode 1: Low-speed voltage and current curve (2sps -> 100sps)
Mode 2: Low-speed D+D-curve (2sps -> 100sps)
Mode 3: High-speed voltage ripple (AC coupling) (5Ksps -> 4Msps)
The following picture shows the sine wave, square wave and triangle wave at 200KHz.
12