User Manual

10.1.5 Setting menu->General->Temperature symbol
Optional on-board temperature display as ℃/℉.
10.1.6 Settings menu -> General -> System language
Currently only Chinese/English is supported. Due to the character size problem,
English will be displayed in the Chinese system, which is a normal phenomenon.
10.1.7 Settings menu -> General -> Current change wake up
Set the wake-up current. When the current change exceeds the wake-up current,
the meter changes from the standby state to the normal working state. When set to 0,
the function is turned off。
10.1.8 Settings menu->General->Bluetooth switch
After closing, Bluetooth data transmission is not possible.
10.1.9 Settings menu -> General -> Gravity direction recognition
When opened, the page direction is automatically switched, after closing, the
page reverse cannot be switched automatically, but you can switch the page direction
by long pressing the OK button on the (6.0.1) concise page.
10.1.10 Settings menu->General->Startup page
Turn on/off the boot page.
10.1.11 Settings menu->General->Restore factory settings
Restore all settings except recorded data.
10.2 Settings menu -> record
Set the configuration required for logging data.
10.2.1 Setting menu->Record->Curve record time
Set the recording time of the voltage and current curve, the maximum is 9 hours,
set to no time without recording. Each time you change the configuration, the curve
will be cleared to 0.
10.2.2 Setting menu->Record->Statistical current threshold
When the current is greater than or equal to the threshold, the capacity, energy,
23