TS-002 mouse sanding machine manual Technical Parameters Product model: TS-002 Motor parameters: US version 120V, 60Hz, 1.0A European version 230-240V/50Hz, 125W English version 230-240V/50Hz, 125W Rated speed: 13,500RPM (no load) Power cord length: 1.8 m / 6 inches Weight: 1kg/2.
8 sheets of 80 mesh sandpaper: 8 sheets of 180 mesh sandpaper: Sanding machine safety instructions Warning: Please follow the instructions in the manual to assemble the sander before starting to use the machine. 1. The position of the hand-held machine with an insulating soft rubber, especially when the sanding may have hidden wires. 2. Protect the lungs. Wear a mask or dust mask during operation, which will reduce the risk of serious respiratory damage. 3. Protect your hearing.
operability of the machine, check the calibration, whether it is firm, whether there is damage to moving parts, etc., which may affect the use. If there is damage to the protective parts or other parts, it needs to be repaired immediately or by an authorized service center. replace. This will effectively reduce the risk of electric shock, fire or other injury. 6. Need to remove the nails on the wood before use, this will effectively reduce the risk of injury. 7.
a dust mask or other device that blocks tiny particles. Vibration safety This product will generate vibration when it is used. Vibrations caused by repeated use or prolonged use may cause temporary or permanent physical damage, especially to opponents, arms and shoulders. To reduce the risk of injury caused by vibration: 1. Please consult a doctor before use and confirm by routine examination that it will not cause medical problems due to the use of the machine.
7. In order to reduce the vibration, please follow the instructions in the manual to maintain the product. If abnormal vibration occurs, stop using it immediately. Know your machine Instructions Workpiece installation and operating area settings 1. Make sure the operating area is clean and well lit. It is necessary to prohibit children or pets from entering the operation area to avoid being injured and causing injuries. 2.
General operating instructions 1. Confirm that the switch is in the off position and then plug the plug into the power source. 2. Turn on the power switch to “I”. 3. Do not apply excessive force during sanding, and need to sand the grain along the grain direction and sandpaper with sandpaper. It is necessary to ensure uniform pressure on the workpiece during operation. 4. Regularly check the sandpaper for wear and replace the sandpaper as needed.
Sandpaper selection Please choose the right size, suitable mesh sandpaper to get the best matte quality. Sandpaper made from alumina, silicon carbide and other synthetic abrasives will give a better matte finish. In general, coarse sandpaper will wear off more material, and fine sandpaper will give the best results. Therefore, the condition of the surface of the matte material determines how to choose the right sandpaper.
Do not use a machine that has been damaged. If abnormal noise or vibration occurs, please find out the cause and repair before use. Before each use, you need to check the conditions of use of the machine. Check the following points: · Is there hardware loose? · Whether there are moving parts that are too tight or not calibrated; ·The power cord is damaged; · Some parts are cracked or broken; · Or there are other situations that affect the safe use of the product.
Problem possible cause A. The machine is not running possible reason: 1. The power cord is not connected; 2. The power supply has no electricity; 3. Internal damage; Solve: 1. Check if the power cord is connected properly; 2. If there is no power on the line, please turn off the machine and check the line problem; 3. Check with the Technical Service Department; B.
2.
