Installation Manual

B1-MT300MIX
17
Note:
1) In this installation mode, a disc filter should be added at the front end of the gas intake of MT300MIX to
prevent impurities from entering the equipment;
2) Hoops shall be installed at hose joints and tightened;
3) Pay attention to the pressure range of MT300MIX: 0.08MPA-0.2MPa;
4) Note that the total length of the pipe from tee to MT300MIX should not exceed 2 meters.
4.2 Installation Method 2
Connect MT300MIX to the final end of the pre-mixing gas pipe through the coupler of the
corresponding incubator;
Note:
1) Hoops shall be installed at hose joints and tightened;
2) Pay attention to the pressure range of MT300MIX: 0.08MPA-0.2MPa;
Manual
ball valve
Pre-mix gas
COOK
incubator
COOK
incubator
COOK
incubator
COOK
incubator
COOK
incubator
Union-assembly
HEPA gas
filter
Mini M-type
hose clamp
Union-assembly
Union-assembly
Union-assembly
Union-assembly