Installation Manual

A3-MT300
13
UP key: Press this button to add the value by
0.01 ℃ and press and hold this button to add
the value by 1 ℃
DOWN key: Press this button to reduce the
value by 0.01 ℃ and press and hold this button
to reduce the value by 1 ℃
OK key: Start calibration again
Menu key: The system returns to the setting
interface when this key is pressed (the system
will save the calibrated value automatically)
Note:
1. Temperature calibration setting range: From 0 ℃ to 50 ℃;
3.2.5 "2.SET O2"
Select "2.SET O2" on the setting interface, and then press the "OK" button to enter the O
2
concentration calibration setting interface, as shown in the picture below:
O
2
Concentration Calibration Interface:
O
2
Concentration Calibration Interface and Operation Instructions When MT300SP Is Not
Connected
UP key: No function
DOWN key: No function
OK key: The system returns to the setting
interface when this key is pressed
Menu key: The system returns to the setting
interface when this key is pressed
Interface and Operation Instructions Upon O
2
Concentration Calibration Failure
UP key: Press this button to add the value by
0.1% and press and hold this button to add the
value by 1%
DOWN key: Press this button to reduce the
value by 0.1% and press and hold this button to