Technical Manual

ManualsBrandsMETRA EASY WIRE SYSTEM ManualsElectronicsElectronic Lock RFID ISO SE

1

2

3

4

5

6

7

8

9

smarter locking

© Metra 2019,

All Rights reserved

The content of this document is subject

To change without notice

Page 10

STEP 6:

Connect the Electronic Lock RFID.

ATTENTION

Pay attention to connector’s orientation. Flat side of

the connector should be orientated towards the back

side of the lock.

STEP 7 (OPTION A):

Placing the cable under the lock. Twist the 6-wire

cable in the rabbet at the back side of the lock as

shown on the picture (two options – depends of the

cabling).

STEP 7 (OPTION B):

Placing the cable under the lock. Twist the 6-wire

cable in the rabbet at the back side of the lock as

shown on the picture (two options – depends of the

cabling).

STEP 8:

Connect the other side of the cable to the connection

plate.

NOTE: Example shows Link 8 connection plate.