Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 11

Three-pole EasyWire cable connectors

Tools required: To crimp the connectors you need

special crimping pliers (can be purchased from Metra

on request).

STEP 1:

Separate approximately 4 centimetres of wires on a 3

pole 0.75mm

cable.

STEP 2:

Place the connector in the pillars as shown on the

photo.

NOTE: Each pin on the connector is marked with a

number from 1 to 3. Some connectors may have

markings on the back side while some on the front

side.

wire colour

Blue wire

White wire

Red wire