Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 14

10. MOUNTING THE LOCK

General rule is that the lock is better to be placed a bit forward of the closed inner plane of the

door and should never be even a fraction back from that plane.

ATTENTION

With the term inner plane of the door we refer to the surface on which the door strike will be placed

and should be able to completely compress the ejector and touch the lock front. All eventual

parameters such as rubber bumpers, bent doors, hinge type, euro deposit pad, etc. should be

taken into consideration.

Mounting holes for the Electronic Lock RFID should be predrilled in factory according to the

specifications in appendices.

OK – Lock tip is even with the

inner plane of the door. The

door will reach the lock tip.

Locking is possible.

OK – Lock tip is over the inner

plane of the door. The door

will reach the lock tip. Locking

is possible.

WRONG! – Lock tip is behind

the inner plane of the door

and the door CANNOT reach

the lock tip. Locking is NOT

possible.

The lock body should be mounted first and then the door strike accordingly. The body is placed on

the locker side (for very narrow doors can be also top or bottom). Drillings should be done in

accordance with the drawing and the screw type. Insert the connector, fold the extra wire (see

"wiring") and screw the lock firmly.

ATTENTION

Do not over-tighten the screws as they can deform the lock. This may stop it from working and

such damages are NOT covered by warranty!