Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 19

Place Metra mounting jig on the loop and firmly close

the door to position the strike and then tighten the

screws. Do not over-tight the screws, the wire loop

should still move freely. Remove the mounting jig.

CORRECTLY TIGHT SCREWS

Try moving the Wire loop left and right in the screws

are correctly tightened, the wire loop should be able

to move.

NOTE: If the lockers are precisely made and quality hinges are used the strike position does not

vary from one to another. According to strike position in the first locker all remaining can be

positioned the same just on optical evaluation to speed-up the assembly procedure. Final

corrections can be done during functional test of the locker if needed.