Technical Manual

smarter locking
© Metra 2019,
All Rights reserved
The content of this document is subject
To change without notice
Page 20
12. FINAL OPERATIONAL TEST OF THE LOCKER
Final check of the locker and mounting should be done after the lock is operational – connected to
the driving or test unit.
CHECK 1:
Press the ejector to check the operation. The motor
should operate swiftly. If not, check the wiring or
loose the screws a bit.
CHECK 2:
Close the doors. When closed and locked, the doors
should have a fraction (1mm) of a "free movement"
under the spring.