Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 21

13. ELECTRONIC LOCK SET-UP

“Locker Controllers” have two operating modes: Construction and Normal.

Enter the Construction mode of operation. Consult appropriate “Locker Controller Technical

Manual” for details.

Initial set-up

Procedure at Setting up new system or changing all lockers connected to one MEW Controller.

First set all DIP switches to 0 (Off) and then reset the

indexes on the connected Electronic Locks RFID by

pressing and holding the PARAMETERS REQUEST button

for more than 8 seconds – untill the second acoustic

signal is generated. When you release the button three

short acoustic signals are generated and all connected

Electronic Locks RFID start blinking in white colour

rapidly, indicationg that the indexes were erased.

NOTE: Lockers must be unlocked before you start the

indexing procedure. To open all lockers press the

emergency open button.

STEP 1:

To index all Electronic Locks RFID connected to the

device start by Electronic Lock RFID with the lowest

locker number and rapidly press the plunger 2 times.

Close the locker door and present the RFID media into

the antenna field for 2 seconds.

STEP 2:

If the Electronic Lock RFID was successfully indexed it

will blink as many times as the set index.

index 1 … 1 blink

index 2 … 2 blinks

index 3 … 3 blinks

…

index 16 … 16 blinks