Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 22

STEP 3:

Repeat the procedure on all connected locks from

lowest to highest locker number.

One locker replacement procedure

NOTE: Always use new lockers without address to avoid confusion with double address.

STEP 1:

Replace broken Electronic Locks RFID with new one.

STEP 1:

Open PC software select appropriate locker and click “LOCK CHANGE”. Index with timeout is send.

STEP 1:

To index new Electronic Lock RFID rapidly press the plunger 2 times in timeout interval.

When two or more locks are damaged, repeat whole procedure for each Electronic Lock RFID.

ATTENTION

If for some reason you are installing Electronic Lock RFID with unknown address, procedure is

different.

14. RFID READER TEST

Enter the RFID test mode of operation. Consult appropriate “Locker Controller Technical Manual”

for details.

STEP 1:

To test the RFID reader close the locker door and hold

them closed. Electronic Lock RFID starts to blink red.