Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 23

STEP 3:

Present the RFID media. When the RFID media is in the

antenna field, the Electronic Lock RFID will start blinking

green.

15. MAINTENANCE OF THE LOCK

If mounted correctly as described above and under normal conditions the lock should give you

long lasting, trouble free operation. Due to the hi-tech and hi quality materials used, there is

virtually no maintenance needed. Occasional (depends on the environment, usually once or twice

a year) cleaning of accumulated dust particles, lubrication of the locking ball with the PTFE (Teflon)

spray and wiping of exceeded lubrication is recommended.

Do not expose the lock to the water dripping or direct water jet when cleaning the cabinet!

Occasional reposition of the door strike might be needed due to the hinge or cabinet construction

wear, depending on the locker quality and frequency of use. The lock construction can handle self

– reposition of approx. 1mm vertical and horizontal disposition if mounted ideally.

Any lock that has endured the brake inn attempt (has been stressed over 80kg) should be replaced.

Thanks to the connector that is relatively simple, only replace the lock body and (if damaged) the

strike, rewiring is not necessary.