Technical Manual

ManualsBrandsMETRA EASY WIRE SYSTEM ManualsElectronicsElectronic Lock RFID ISO SE

smarter locking

The content of this document is subject

To change without notice

Page 4

2. REGULATORY INFORMATION

Manufacturer:

Metra inženiring d.o.o.

IOC Trzin

Špruha 19

SI-1236 Trzin, Slovenia

phone:

fax:

web:

+386 1 56 10 740

+386 1 56 10 744

www.metra.si

Trade Mark:

Metra MEW System

Model/Type ref.:

Electronic Lock RFID ISO SE

Part Number:

1838

FCC ID:

2ABT80008P1838

Year of Construction:

2019

This product is in conformity with the essential requirements and other relevant requirements of the

following EU Directives:

• RoHS Recast (RoHS2) Directive 2011/65/EU of the European Parliament and of the Council on

the restriction of the use of certain hazardous substances in electrical and electronics

equipment.

• RED - Radio Equipment Directive (2014/53/EU).

Environmental Information for EU customers – WEEE Directive Statement:

This symbol indicates the product is in conformity with the protection requirements of European Council

Directive 2012/19/EU. It requires that products marked with this symbol must not be disposed of with

unsorted municipal waste.

This product must be disposed of separately from household waste via designated collection facilities

appointed by local authorities. Please contact your local authorities or waste disposal service for more

detailed information.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.