Technical Manual

smarter locking

The content of this document is subject

To change without notice

Page 6

5. COMPONENTS

Electronic Lock RFID ISO SE

Base, strike and front cover

Connection plates

Cabling

6. LOCK POSITION

The lock position has to be identified before the process of wiring. General recommendation is that

the lock should be positioned near to the handle, so the users are operating the locks as directly

as possible. Position may thus vary due to the locker construction, vertical position, etc. The screws

are not supplied since they vary in size and type for different locker constructions and materials.

7. WIRING

Electronic Lock RFID is connected to the connection plate which is part of a Metra EasyWire

Network main line, by six-wire flat cable. For main line connection a three-wire cable is used. The

lock, uncut wires, connectors and connection plates are supplied separately for adjustability to

different situations (wire - lengths), easier process of wiring during installation and later

maintenance. Different types of connection plates are available to suit different locker model. First

identify the position of the locks and corresponding controller (up to 16 locks to one controller).

Find the most suitable way for the wires from the controller to its locks and install the cables. Be

sure to leave cable long enough to be connected to the lock before mounting it (approx. +5 cm).