Installation Manual

1.800.221.0932
|
MetraOnline.com
14
DASH DISASSEMBLY 95-2001 OR 99-2001
Hummer H2 2003-2007
1. Open center console and remove (4)
9/32” screws from console box and
remove box. (Figure A)
2. Remove (4) Phillips screws from
hinge on console door inside console
and remove door. (Figure B)
3. Loosen (1) T-15 torx on forward facing
side of shift lever and pull up to
remove. (Figure C)
4. Unclip cup holder/shifter trim
assembly and remove. (Figure D)
5. Remove (6) Phillips screws from top
of center console. (Figure F)
6. Remove (2) Phillips screws from
inside pocket on back of center
console, then unclip and remove.
7. Remove (1) 10mm bolt to right of shift
lever. (Figure E)
8. Remove (2) Phillips screws from
under console box on drivers side and
(2) Phillips screws from under console
trimtop on passenger side. (Figure F)
9. Slide control assembly rearwards.
(Figure F)
10. Remove (2) T-30 torx bolts from top
of rado/climate control trim and
unclip and remove. (Figure G)
11. Remove (3) 9/32” screws that hold
the radio in. (Figure G)
Continue to Kit Assembly
(Figure G)
(Figure A) (Figure B) (Figure C) (Figure D)
(Figure E) (Figure F)
Step 3
Step 2
Step 4
Step 1
Step 5
Step 9
Step 8