Installation Manual

REV. 7/14/2017 INST-2001
19
KIT ASSEMBLY
ISO DDIN radio provision (95-2001):
1. Attach the radio brackets to the inside
edge of the radio trim plate . (Figure A)
2. Slide the radio into the completed
assembly, and then secure the radio to
the assembly using the screws supplied
with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
4. Reassemble the dash in reverse order of
disassembly.
Note: The spacers included in the kit
may be necessary to adapt to the slight
differences from one vehicle to another.
If the kit/radio assembly does not
meet the backside of the factory radio
opening, use the spacers to eliminate
that space.
(Figure A) (Figure A)
(Figure B) (Figure B)
ISO DIN radio provision with pocket (99-2001):
1. Attach the radio brackets to the inside
edge of the radio trim plate . (Figure A)
2. Slide the pocket into the assembly,
and then secure using the (4) #8 x 3/8”
Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure using the
screws supplied with the radio. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation .
6. Reassemble the dash in reverse order of
disassembly.
Note: The spacers included in the kit
may be necessary to adapt to the slight
differences from one vehicle to another. If
the kit/radio assembly does not meet the
backside of the factory radio opening,
use the spacers to eliminate that space .