Installation Manual

1.800.221.0932
|
MetraOnline.com
4
DASH DISASSEMBLY 95-2001 OR 99-2001
Buick Century 1997-2005
Buick Regal 1995-2004
1. Remove the plastic trim piece to the left of the glove box
and (1) Phillips screw exposed.
2. Unsnap the top edge of the knee bolster panel.
3. Remove (1) Phillips screw from the panel.
4. Remove the ashtray cluster and (2) Phillips screws from
each side.
5. Unclip the entire dash trim bezel and remove.
6. Open doors and unsnap end caps from each side of dash.
7. Unsnap and remove radio/instrument cluster panel.
8. Remove (3) screws in order to remove radio.
Continue to Kit Assembly
(Figure A)
Buick Le Sabre/Buick Park Avenue 1995-1999
1. Unsnap the climate control trim panel (from door to
door) and remove (4) Phillips screws exposed. (Figure A)
2. Pop out the a/c vents and remove (1) Phillips screw
exposed in each vent cavity. (Figure A)
3. Unclip the radio trim bezel and remove.
4. Remove the screws securing the factory radio and
disconnect the wiring.
Continue to Kit Assembly
(Figure A)
Buick Le Sabre/Buick Park Avenue 2000-2005
1. Open drivers door and unsnap and remove dash end cap.
2. Unsnap and remove trim along center of dash (one piece
on right and one on left of wheel).
3. Unsnap and remove radio/instrument bezel.
4. Remove (2) screws in order to remove radio.
Note: For the Buick LeSabre, (3) speed clips and screws
will need to be supplied to attach the kit into the sub-
dash where the screw holes line up with the kit.
Continue to Kit Assembly
(Figure A)
1 1 11 1
2
2
2 2
4
4
4