User Manual

1. Unsnap left side panel exposing (1)

Phillips screw to remove.

2. Remove (1) Phillips screw and

unsnap right side panel to expose

(1) Phillips screw beneath panel

and remove.

3. Unsnap underside of overhanging

dash to unsnap (6) plastic rivets and

remove panel.

4. Remove (5) hex-head screws now

exposed under overhang.

5. Unsnap bottom edge of trim bezel,

then while holding overhang up,

unsnap and remove trim bezel by

removing any necessary harnesses.

6. Remove (3) Phillips screw to remove

climate control.

7. Remove (2) Phillips screws to

remove rear support and (3) 9/32”

Continue to kit assembly

Buick Riviera 1996-1999

(Figure A)

1. Unclip dash panel sides and remove.

2. Unclip panel below steering column and remove.

3. Remove (2) 7mm screws above instrument cluster.

4. Set parking brake, turn car on, and move shifter to the lowest gear. Tilt steering

wheel down then unsnap entire instrument cluster/radio panel and remove.

5. Remove (3) 7mm screws to remove radio.

Continue to kit assembly

Buick Roadmaster 1995-1996

(Figure A)

Dash Disassembly

Step 1

Step 2

Step 5

Step 3

Step 4

Step 3

Step 1

Step 2