Car Stereo System User Manual

ManualsBrandsMetra Electronics ManualsAutomobile Accessories95-7418

INSTALLATION INSTRUCTIONS FOR PART 95-7418

Flat Blade Scr

ewdriver I Phillips Scr

ewdriver

1-800-221-0932 www.metraonline.com

KIT FEATURES

• DDIN Head Unit Provision

• STACKED ISO DIN Head Unit Provision

A) Trim Plate

KIT COMPONENTS

TOOLS REQUIRED:

95-7418

APPLICATIONS

2002-2004 Nissan Altima

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-7418 APPLICATIONS 2002-2004 Nissan Altima 95-7418 KIT FEATURES • DDIN Head Unit Provision • STACKED ISO DIN Head Unit Provision KIT COMPONENTS A) Trim Plate A TOOLS REQUIRED: Flat Blade Screwdriver I Phillips Screwdriver 1-800-221-0932 www.metraonline.
PAGE 2
95-7418 TABLE OF CONTENTS Dash Disassembly ............................................................................ 1 Kit Assembly ................................................................................. 2-3 Final Assembly .................................................................................
PAGE 3
95-7418 DASH DISASSEMBLY 2002-2004 NISSAN ALTIMA 1 Disconnect the negative battery terminal to prevent an accidental short circuit. A 2 Unclip and remove the trim panel surrounding the climate controls. (Figure A) 3 Remove (1) Phillips screw (bottom right side of panel) securing the panel surrounding the radio then unclip and remove the panel. (Figure B,C) 4 Remove (4) Phillips screws securing radio to remove.
PAGE 4
95-7418 KIT ASSEMBLY DOUBLE DIN HEAD UNIT PROVISION 1 Snap the 95-7418 trim plate into the radio trim panel. (Figure A) A Install from rear 2 Slide the DDIN radio unit into the factory brackets and secure the unit to the brackets using the screws supplied with the head unit.
PAGE 5
95-7418 KIT ASSEMBLY STACKED ISO DIN HEAD UNIT PROVISION 1 Snap the 95-7418 trim plate into the radio trim panel. (Figure A) A Install from rear 2 Slide the stacked ISO DIN units into the factory brackets and secure the units to the brackets using the screws supplied with the head unit.
PAGE 6
95-7418 FINAL ASSEMBLY FINAL ASSEMBLY 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly.
PAGE 7
95-7418 NOTES 5
PAGE 8
95-7418 INSTRUCTIONS 1-800-221-0932 REV. 09/06/07 www.metraonline.